Specification item 12E 18E (Standard) 25E
Screw diameter (mm) AA
28		 A
32		 B
36		 AA
32		 A
36		 B
40		 AA
36		 A
40		 B
45
Injection capacity(cm3) 77 101 127 117 148 182 163 201 254
Plasticization capacity [PS] (kg/h) 28 40 54 40 54 75 54 75 102
Max. injection pressure
(MPa [kgf/cm2])		 265 223 176 265 218 176 255 211 167
Injection rate
(cm3/s)		 Standard 166 217 275 161 204 251 178 220 278
High velocity 201 255 314 254 314 398
High load 135 177 224 161 204 251 183 226 286
Injection velocity (mm/s) Standard 270 200 175
High velocity 250 250
High load 220 200 180
Screw velocity (rpm) 0 ~ 300 0 ~ 300 0 ~ 300
Nozzle touch force (kN) 17 17 17
Hopper capacity [Optional] (L) 25 25 45
Clamping force (kN [tf]) 1373[140] 1373[140] 1373[140]
Clamping stroke (mm) 400 400 400
Mold thickness [min. - max.] (mm) 220 ~ 450 220 ~ 450 220 ~ 450
Max. daylight opening (mm) 850 850 850
Tie bar clearance [H x V] (mm) 510 x 460 510 x 460 510 x 460
Die plate dimensions [H x V] (mm) 720 x 670 720 x 670 720 x 670
Min. mold dimensions [H x V] (mm) 325 x 325 325 x 325 325 x 325
Locating ring diameter (mm) 120 120 120
Ejector force (kN) 35 35 35
Ejector stroke (mm) 110 110 110
Heater band capacity (kW) 7.98 9.13 8.88 10.57 10.54 13.01
Machine dimensions [L x W x H] (m) 4.84 x
1.32 x
1.81		 4.87 x
1.32 x
1.81		 5.04 x
1.32 x
1.81		 4.97 x
1.32 x
1.81		 5.16 x
1.32 x
1.81
Floor dimensions [L x W] (m) 4.37 x 0.93 4.37 x 0.93 4.37 x 0.93
Machine weight (t) 6.1 6.3 6.9
Actual plasticizing capacity may vary, depending on the molding conditions and materials used.
The maximum injection pressure denotes the output of the injection unit, not the resin pressure.
The maximum injection pressure is the highest value that can be set on the machine. The value may be limited, depending on the molding conditions.
The maximum injection rate in the table is the estimated value that was derived from a formula, and it is not guaranteed value at the maximum injection pressure.
The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used.
The specifications are subject to change without notice due to performance upgrades.
1MPa=10.2kgf/cm2≒10kgf/cm2,1kN=0.102tf≒0.1tf
back

(C)2004 Nissei Plastic Industrial Co., Ltd.