Specification item 5E 9E (Standard) 12E
Screw diameter (mm) A
22		 B
26		 BB
28		 AA
26		 A
28		 B
32		 AA
28		 A
32		 B
36
Injection capacity(cm3) 35 49 57 59 69 90 77 101 127
Plasticization capacity [PS] (kg/h) 16 23 32 19 28 40 28 40 54
Max. injection pressure (MPa [kgf/cm2]) 255 196 169 265 243 186 265 223 176
Injection rate (cm3/s) Standard 190 265 308 159 185 241 166 217 275
High velocity
High load 133 186 216 127 148 193 135 177 224
Injection velocity (mm/s) Standard 500 300 270
High velocity
High load 350 240 220
Screw velocity (rpm) 0 ~ 50 0 ~ 300 0 ~ 300
Nozzle touch force (kN) 13 13 13
Hopper capacity [Optional] (L) 15 25 25
Clamping force (kN [tf]) 784[80] 784[80] 784[80]
Clamping stroke (mm) 300 300 300
Mold thickness [min. - max.] (mm) 200 ~ 385 200 ~ 385 200 ~ 385
Max. daylight opening (mm) 685 685 685
Tie bar clearance [H x V] (mm) 420 x 420 420 x 420 420 x 420
Die plate dimensions [H x V] (mm) 580 x 580 580 x 580 580 x 580
Min. mold dimensions [H x V] (mm) 295 x 295 295 x 295 295 x 295
Locating ring diameter (mm) 100 100 100
Ejector force (kN) 20 20 20
Ejector stroke (mm) 75 75 75
Heater band capacity (kW) 4.96 5.73 6.16 7.22 8.36 9.26 7.98 9.13
Machine dimensions [L x W x H] (m) 4.00 x 1.12 x 1.68 4.19 x 1.12 x 1.68 4.27 x 1.12 x 1.68 4.24 x 1.12 x 1.68 4.33 x 1.12 x 1.68
Floor dimensions [L x W] (m) 3.58 x 0.75 3.58 x 0.75 3.58 x 0.75
Machine weight (t) 3.5 3.7 3.7
Actual plasticizing capacity may vary, depending on the molding conditions and materials used.
The maximum injection pressure denotes the output of the injection unit, not the resin pressure.
The maximum injection pressure is the highest value that can be set on the machine. The value may be limited, depending on the molding conditions.
The maximum injection rate in the table is the estimated value that was derived from a formula, and it is not guaranteed value at the maximum injection pressure.
The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used.
The specifications are subject to change without notice due to performance upgrades.
1MPa=10.2kgf/cm2≒10kgf/cm2,1kN=0.102tf≒0.1tf
back

(C)2004 Nissei Plastic Industrial Co., Ltd.