Specification item 18E 25E (Standard) 36E (Standard)
Screw diameter (mm) AA
32		 A
36		 B
40		 AA
36		 A
40		 B
45		 AA
40		 A
45		 B
50
Injection capacity(cm3) 117 148 182 163 201 254 226 286 353
Plasticization capacity [PS] (kg/h) 40 54 75 54 75 102 62 91 115
Max. injection pressure
(MPa [kgf/cm2])		 265 218 176 255 211 167 245 206 167
Injection rate
(cm3/s)		 Standard 161 204 251 178 220 278 220 278 344
High velocity 201 255 314 254 314 398 314 398 491
High load 161 204 251 183 226 286 226 286 353
Injection velocity (mm/s) Standard 200 175 175
High velocity 250 250 250
High load 200 180 180
Screw velocity (rpm) 0 ~ 300 0 ~ 300 0 ~ 250
Nozzle touch force (kN) 23 23 23
Hopper capacity [Optional] (L) 25 45 45
Clamping force (kN [tf]) 1765[180] 1765[180] 1765[180]
Clamping stroke (mm) 450 450 450
Mold thickness [min. - max.] (mm) 250 ~ 510 250 ~ 510 250 ~ 510
Max. daylight opening (mm) 960 960 960
Tie bar clearance [H x V] (mm) 560 x 560 560 x 560 560 x 560
Die plate dimensions [H x V] (mm) 800 x 800 800 x 800 800 x 800
Min. mold dimensions [H x V] (mm) 395 x 395 395 x 395 395 x 395
Locating ring diameter (mm) 120 120 120
Ejector force (kN) 39 39 39
Ejector stroke (mm) 110 110 110
Heater band capacity (kW) 8.88 10.57 10.54 13.01 12.53 15.53
Machine dimensions [L x W x H] (m) 5.37 x 1.37 x 2.00 5.37 x 1.37 x 2.00 5.43 x 1.37 x 2.00 5.58 x 1.37 x 2.00 5.68 x 1.37 x 2.00
Floor dimensions [L x W] (m) 4.85 x 0.96 4.85 x 0.96 4.85 x 0.96
Machine weight (t) 7.0 7.6 7.9
Actual plasticizing capacity may vary, depending on the molding conditions and materials used.
The maximum injection pressure denotes the output of the injection unit, not the resin pressure.
The maximum injection pressure is the highest value that can be set on the machine. The value may be limited, depending on the molding conditions.
The maximum injection rate in the table is the estimated value that was derived from a formula, and it is not guaranteed value at the maximum injection pressure.
The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used.
The specifications are subject to change without notice due to performance upgrades.
1MPa=10.2kgf/cm2≒10kgf/cm2,1kN=0.102tf≒0.1tf
back

(C)2004 Nissei Plastic Industrial Co., Ltd.