Specification item 71E (Standard) 100LE Screw diameter (mm) AA 50 A 56 B 63 AA 50 A 56 B 63 Injection capacity(cm3) 442 554 701 550 776 982 Plasticization capacity [PS] (kg/h) 115 156 209 115 156 209 Max. injection pressure (MPa [kgf/cm2]) 249 199 157 249 199 157 Injection rate (cm3/s) Standard 314 394 499 314 394 499 High velocity 393 493 623 393 493 623 High load 314 394 499 314 394 499 Injection velocity (mm/s) Standard 160 160 High velocity 200 200 High load 160 160 Screw velocity (rpm) 0 ~ 250 0 ~ 250 Nozzle touch force (kN) 29 29 Hopper capacity [Optional] (L) 90 90 Clamping force (kN [tf]) 2740 2740 Clamping stroke (mm) 600 600 Mold thickness [min. - max.] (mm) 320 ~ 610 320 ~ 610 Max. daylight opening (mm) 1210 1210 Tie bar clearance [H x V] (mm) 660 x 660 660 x 660 Die plate dimensions [H x V] (mm) 955 x 955 955 x 955 Min. mold dimensions [H x V] (mm) 465 x 465 465 x 465 Locating ring diameter (mm) 120 120 Ejector force (kN) 59 59 Ejector stroke (mm) 130 130 Heater band capacity (kW) 17.74 21.98 17.53 22.17 Machine dimensions [L x W x H] (m) 6.41 x 1.62 x 2.10 6.60 x 1.62 x 2.10 6.57 x 1.62 x 2.10 6.72 x 1.62 x 2.10 Floor dimensions [L x W] (m) 5.99 x 1.18 5.99 x 1.18 Machine weight (t) 14.5 14.8 Actual plasticizing capacity may vary, depending on the molding conditions and materials used. The maximum injection pressure denotes the output of the injection unit, not the resin pressure. The maximum injection pressure is the highest value that can be set on the machine. The value may be limited, depending on the molding conditions. The maximum injection rate in the table is the estimated value that was derived from a formula, and it is not guaranteed value at the maximum injection pressure. The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used. The specifications are subject to change without notice due to performance upgrades. 1MPa=10.2kgf/cm2≒10kgf/cm2,1kN=0.102tf≒0.1tf back

(C)2004 Nissei Plastic Industrial Co., Ltd.