Specification item 100LE (Standard) 140LE Screw diameter (mm) AA 50 A 56 B 63 A 63 B 71 Injection capacity(cm3) 550 776 982 1107 1406 Plasticization capacity [PS] (kg/h) 115 156 209 209 246 Max. injection pressure (MPa [kgf/cm2]) 249 199 157 201 158 Injection rate (cm3/s) Standard 314 394 499 499 633 High velocity 393 493 623 - - High load 314 394 499 - - Injection velocity (mm/s) Standard 160 160 High velocity 200 - High load 160 - Screw velocity (rpm) 0 ~ 250 0 ~ 250 0 ~ 210 Nozzle touch force (kN) 29 39 Hopper capacity [Optional] (L) 90 90 Clamping force (kN [tf]) 3530[360] 3530[360] Clamping stroke (mm) 650 650 Mold thickness [min. - max.] (mm) 350 ~ 690 350 ~ 690 Max. daylight opening (mm) 1340 1340 Tie bar clearance [H x V] (mm) 735 x 735 735 x 735 Die plate dimensions [H x V] (mm) 1055 x 1055 1055 x 1055 Min. mold dimensions [H x V] (mm) 520 x 520 520 x 520 Locating ring diameter (mm) 120 120 Ejector force (kN) 78 78 Ejector stroke (mm) 150 150 Heater band capacity (kW) 17.53 22.17 28.4 Machine dimensions [L x W x H] (m) 6.81x 1.74x 2.10 6.97 x 1.74 x 2.10 7.33 x 1.78 x 2.21 Floor dimensions [L x W] (m) 6.19 x 1.24 6.86 x 1.24 Machine weight (t) 16.0 18.5 Actual plasticizing capacity may vary, depending on the molding conditions and materials used. The maximum injection pressure denotes the output of the injection unit, not the resin pressure. The maximum injection pressure is the highest value that can be set on the machine. The value may be limited, depending on the molding conditions. The maximum injection rate in the table is the estimated value that was derived from a formula, and it is not guaranteed value at the maximum injection pressure. The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used. The specifications are subject to change without notice due to performance upgrades. 1MPa=10.2kgf/cm2≒10kgf/cm2,1kN=0.102tf≒0.1tf back

(C)2004 Nissei Plastic Industrial Co., Ltd.