Specification item 3E 5E (Standard) Screw diameter (mm) A 19 B 22 A 22 B 26 BB 28 Injection capacity(cm3) 23 35 35 49 57 Plasticization capacity [PS] (kg/h) 11 16 16 23 32 Max. injection pressure (MPa [kgf/cm2]) 255 210 255 196 169 Injection rate (cm3/s) Standard 142 190 190 265 308 High velocity High load 133 186 216 Injection velocity (mm/s) Standard 500 500 High velocity High load 350 Screw velocity (rpm) 0 ~ 350 0 ~ 350 Nozzle touch force (kN) 13 13 Hopper capacity [Optional] (L) 15 15 Clamping force (kN [tf]) 490[50] 490[50] Clamping stroke (mm) 250 250 Mold thickness [min. - max.] (mm) 170 ~ 360 170 ~ 360 Max. daylight opening (mm) 610 610 Tie bar clearance [H x V] (mm) 360 x 360 360 x 360 Die plate dimensions [H x V] (mm) 505 x 505 505 x 505 Min. mold dimensions [H x V] (mm) 255 x 255 255 x 255 Locating ring diameter (mm) 100 100 Ejector force (kN) 20 20 Ejector stroke (mm) 70 70 Heater band capacity (kW) 4.48 4.96 4.96 5.73 6.16 Machine dimensions [L x W x H] (m) 3.43 x 1.05 x 1.60 3.43 x 1.05 x 1.60 3.52 x 1.05 x 1.60 3.56 x 1.05 x 1.60 Floor dimensions [L x W] (m) 3.09 x 0.72 3.09 x 0.72 Machine weight (t) 2.6 2.6 Actual plasticizing capacity may vary, depending on the molding conditions and materials used. The maximum injection pressure denotes the output of the injection unit, not the resin pressure. The maximum injection pressure is the highest value that can be set on the machine. The value may be limited, depending on the molding conditions. The maximum injection rate in the table is the estimated value that was derived from a formula, and it is not guaranteed value at the maximum injection pressure. The clamping force on the table may be lower when a mold smaller than the indicated minimum mold size is used. The specifications are subject to change without notice due to performance upgrades. 1MPa=10.2kgf/cm2≒10kgf/cm2, 1kN=0.102tf≒0.1tf back

(C)2004 Nissei Plastic Industrial Co., Ltd.